SAP PI/PO Reprocessing pattern

Facebooktwittergoogle_pluslinkedintumblr

This pattern is used when you want to process the message two times. It can often occur when you have a look up in your message, and you want to use this data to process the full message. Normally you could do routing in the receiver determination mapping, but then you would have to call the same service again in the next mapping following. If those transactions or the high load of data that you want to look up in this it’s going to be a little challenging using this receiver determination mapping and in the real mapping. That is where this reprocessing pattern makes sense because you’re reusing the data for both routing and mapping.

It is quite simple you simply sent the message back into SAP PI/PO system using the soap adapter, and then on the second ICO setup a SOAP adapter.

Read more about the other patterns for SAP Integration at http://picourse.com/patterns

 

Facebooktwittergoogle_pluslinkedintumblr

Comments are closed.